Filter
Top Products
Non-Horizontal Applications
If installing these panels at 45° or less, hand punch a nail slot
in the vinyl or drill a clearance hole just above the lock hoop
area in the middle of the panel. You will “hang” the panel from
the center pin, so hand nail the center pin as you would a
typical vinyl siding panel. Then fasten the flexible hem. For
Starburst installation, see pages 109-111.
Installing Millennium without a Starter Strip
To install Millennium without a starter strip, install J-channel in
place of the starter strip. Then hand punch a nail slot in the
Millennium panel or drill a clearance hole just above the lock
hoop area in the middle of the panel. “Hang” the panel from
the center pin as you would a typical vinyl siding panel. Hand
nail the center pin. If the panel is less than 16", secure it with
two fasteners; otherwise, fasten the panel every 16" o.c.
Removing Panels
To remove a panel, simply unlock the panel from the one
above to expose the flexible nail hem. Use a razor knife to cut
along the PermaFlex cables. Leave the nail hem on the wall or
simply cut “V”s around each fastener to save the panel for
another area. You can also use a flat prybar and work under
the fasteners, prying each one out of the substrate.
hand punched
nail slot
hand punched
nail slot
J-channel
105
Wolverine Fit and Finish Installation Guide