Filter
Top Products
14 UNT-IOM-6
o 9. Complete condensate drain line connections on fan-coil
units.
o 10. Install automatic changeover sensor option on the
supply water line.
o 11. Install automatic electric heat lockout switch option on
the supply water line.
o 12. Install condensate overflow switch option correctly on
the auxiliary drain pan.
o 13. Install the low temperature detection device option correctly.
o 14. Complete all necessary duct connections.
o 15. Complete all interconnection wiring for the wall mounted fan
mode switch or zone sensor per the wiring schematic and guidelines
established in the Wall Mounted Control Interconnection Wiring
section on page 35.
o 16. Install the wall mounted fan mode switch, or zone sensor
module options properly.
o 17. Connect electrical supply power according to the NEC and
unit wiring diagrams.
o 19. Remove any miscellaneous debris, such as sheetrock, that
may have infiltrated the unit during construction.
o 20. Replace the air filter as required.