Filter
Top Products
97663032 A
Page 73
SETTING THE MM SPINUP OPTION
When enabled, the (Media Management Spin Up) MM SpinUp option allows the LaserDrive to read
necessary media management information during spin up. If not enabled, the media management
information will be recovered on the first media access command.
Perform the following procedure to enable or disable the MM SpinUp option:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "MMSpinUp:" is displayed.
5. Press the SELECT switch to scroll through the states for the load switch (off, on). When the
desired state is displayed, press MENU to enter the state and move to the next option in the
Set Configuration menu.
6. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.
SELECT TARGET NEGOTIATION
The Negotiation menu allows the Drive to be set to initiate the NEGOTIATE for SCSI Wide and SCSI
Synchronous communication.
Perform the following procedure to enable or disable the MM SpinUp option:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "Negotiation" is displayed.
5. Press SELECT switch. "TargSDTR" is displayed. Press SELECT to toggle between OFF or
ON.
6. When the desired selection has been made, press MENU to display TargWDTR.
7. Press SELECT to toggle between OFF and ON.
8. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.