Filter
Top Products
PLASMON L M S - LF 8600 USER MANUAL
Page 48
CONNECTING POWER AND SCSI CABLES
After the LF 8600 has been installed in its operating location, refer to the next three sections for power cord
installation and SCSI cable installation for a single device.
The LF 8600 has two SCSI input/output (I/O) connectors on the rear panel that are used to interface the
drive with other SCSI devices (see figure below). Either SCSI connector can be used as the input or output
port because the internal controller cable connection is common to both connectors.
Figure 27. Rear Panel of the LF 8600 Showing SCSI Connectors and AC Power Cord
CONNECTING THE POWER CORD
To install the power cord on an LF 8600:
1. Ensure that an AC power cord is available and ready for installation. The type of AC power
cord being installed depends upon the installation location.
2. Ensure facility power is available and the AC power cord connector (male end) will match the
site AC power wall outlet.
3. Ensure that the AC power switch on the LF 8600 rear panel is set to the OFF ( O ) position.
4. Plug the AC power cord connector (female end) into the AC power receptacle on the
LF 8600 rear panel.
5. Plug the AC power cord connector (male end) into a wall outlet.
AC POWER
CABLE
SCSI
CONNECTORS
AC POWER
SWITCH