Filter
Top Products
PLASMON L M S - LF 8600 USER MANUAL
Page 68
SETTING THE BUS PARITY CHECKING
SCSI bus parity generation is always enabled; however, SCSI bus parity checking at the drive can be
disabled.
Perform the following procedure to turn parity checking on or off:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "Parity:" is displayed.
5. Press the SELECT switch to scroll through the states for parity checking (on, off). When the
desired state is displayed, press MENU to enter the state and move to the next option in the
Set Configuration menu.
6. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the Main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.
SETTING THE LANGUAGE
The language option enables the user to select the language used by the LF 8600 to display messages in
the Operating mode. (English is the only available language for Configuration mode.)
Perform the following procedure to set the operating mode display language:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "Language:" is displayed.
5. Press the SELECT switch to scroll through the language display options (Eng = English, Frh =
French, Grm = German). When the desired language option is displayed, press MENU to
enter the language option and move to the next option in the Set Configuration menu.
6. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the Main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.