Filter
Top Products
97663032 A
Page 49
CONNECTING MULTIPLE DEVICES
To install SCSI interface cables for a multiple-device configuration:
1. Ensure that the SCSI interface cables and a terminator (if required) are available and ready
for installation.
2. Plug one end of a SCSI interface cable into the vacant SCSI interface connector on the
previous device in the SCSI chain (see figure below). Plug the other end of the cable into a
SCSI connector.
3. If the LF 8600 is not the last unit in the daisy chain, plug one end of the other cable into the
vacant connector on the LF 8600 and then connect the other end of the cable to the next
SCSI device. Repeat this process until you reach the last SCSI device in the daisy chain.
4. If the LF 8600 is the last unit in the daisy chain, install a terminator on the LF 8600's vacant
SCSI connector.
5. Ensure that the SCSI bus is also terminated at the host adapter end.
The SCSI bus must be terminated at both ends in accordance with the LD 8100/LF 8120/LF 8600/
LF 8602 SCSI Interface Specification (P/N 97662164).
Figure 28. Multiple LF 8600 SCSI Interface Cable Connections
OUT TO NEXT
SCSI DEVICE
FROM LAST
SCSI DEVICE