Filter
Top Products
PLASMON L M S - LF 8600 USER MANUAL
Page 72
SETTING THE BUSY OPTION
When enabled, the “Busy” message is displayed at the DOC during a spin up or spin down operation.
Enabling this option will cause the Drive to respond to a Start command (via SCSI or MCLI) with a "BUSY"
message over SCSI.
Perform the following procedure to enable or disable the BUSY option:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "Busy:" is displayed.
5. Press the SELECT switch to scroll through the states for the load switch (on, off). When the
desired state is displayed, press MENU to enter the state and move to the next option in the
Set Configuration menu.
6. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.
SETTING THE MODSEL RA OPTION
ModSel RA setting determines if the Drive will acknowledge a Mode Select from the host that changes the
state of the Read Ahead. When disabled, the Drive will ignore a MODSEL RA send over SCSI.
Perform the following procedure to enable or disable the ModSel RA option:
1. Enter the Configuration mode by pressing both the LOAD/MENU and TEST/SELECT
switches simultaneously.
2. Press the MENU switch until "Set Config" is displayed.
3. Press the SELECT switch to enter the Set Configuration menu.
4. Press the MENU switch until "ModSelRA:" is displayed.
5. Press the SELECT switch to scroll through the states for the load switch (on, off). When the
desired state is displayed, press MENU to enter the state and move to the next option in the
Set Configuration menu.
6. Simultaneously press the LOAD/MENU and TEST/SELECT switches to move up to the main
menu. Simultaneously press the LOAD/MENU and TEST/SELECT switches again to exit
Configuration mode.