Filter
Top Products
PLASMON L M S - LF 8600 USER MANUAL
Page 50
CONNECTING A SINGLE DEVICE
To install a SCSI interface cable for a single-device configuration:
1. Plug one end of the SCSI interface cable into the vacant SCSI interface connector on the host
(see figure below).
2. Plug the other end of the interface cable into a SCSI I/O connector on the LF 8600 rear panel.
Figure 29. Single LF 8600 SCSI Interface Cable and Terminator Connection
3. Install a terminator on the vacant connector of the LF 8600.
4. Ensure that the SCSI bus is also terminated at the host adapter end.
The SCSI bus must be terminated at both ends in accordance with the LD 8100/LF 8120/LF 8600/LF 8602
SCSI Interface Specification (P/N 97662164).
IN FROM
HOST
TERMINATOR