65
To arm or disarm all alarms
Every time you press the ALARM/ALM SUSPEND but-
ton while holding down the SHIFT button, all alarms will
be armed or disarmed.
Note: To arm or disarm an alarm, activate Allow Disarm for
the alarm. (Refer to the Admin Console User's Guide
for details.)
■
To Operate Alarm-related
Camera (ACK)
You can operate the camera associated with the alarm
action as follows:
1. Perform Step 1 and 2 of Alarm Selection.
2. Enter a desired alarm action number by pressing the
numeric buttons.
Note: If you skip this step, Alarm Action #0 will be
specified.
3. Press the ACK button.
"Ack:nn" will appear on the LCD.
4. Control the cameras with the system controller.
(Refer to p. 58 Camera Site Accessories Control.)
Note: To select another alarm, press the ALARM/ALM
SUSPEND button. The ACK status will be canceled
(cancelled). Then, enter the alarm action number
by pressing the numeric buttons, and press the
ALARM/ALM SUSPEND button again.
■
To Cancel Alarms
1. Perform Step 1 to 2 of p. 64 Alarm Selection.
2. Press the ALM RESET/ALM ALL RESET button to reset
the alarm. "Reset" will be displayed on the LCD.
Notes:
• To reset all the alarms at a time, press the ALM
RESET/ALM ALL RESET button while holding down
the SHIFT button.
• After the alarm is deactivated, "Armed" or "Cleared"
will be displayed on the LCD.
