Filter
Top Products
54
LCD Display Descriptions
■ Default Status (LCD Display
After Login)
q Monitor number
The number of connected monitor is displayed.
w Unit number/Status
The number of connected site will be displayed.
e Camera number
The number of selected camera is displayed.
r Input number/Recorder number/Status
The numeric input, selected recorder number, or status
is displayed.
■ Blinking
In this document, grayed (greyed) areas on the LCD illus-
trations mean blinking.
■ Messages Displayed on the
LCD
The following are examples of LCD display after login.
Note: Some parts of LCD displays, described on this docu-
ment, may differ from the actual status.
● Invalid
This message is displayed in the following circumstances.
• When you have entered a wrong user ID or password,
etc.
• When you have entered a camera number or monitor
number, etc. that is not existing.
● Busy
• When a selected monitor is controlled by a higher-level
user, "∗" blinks on the LCD. (You cannot control the
monitor.)
• When a selected camera is controlled by a higher-level
user, "∗" blinks on the LCD. (You cannot control the
camera.)
• To cancel the Busy status, select another monitor, cam-
era, or wait until "∗" goes out.
● Prohibit (Prohibited)
• When you have tried an operation not authorized by the
system unit, "Prohibited" is displayed on the LCD.
• When you have forgotten to select a monitor before
selecting a camera, "Prohibited" is displayed on the
LCD.
• After a few seconds, the LCD display will return to the
default status.
MON Invalid CAM
0001 Unit:01 00001
MON Prohibit CAM∗
0001 Unit:01 00001
"Bus
y
" status is activated for a camera.
∗ MON Prohibit CAM
0001 Unit:01 00001
"Busy" status is activated for a monitor.
MON Prohibit CAM
0001 Unit:01 00001
∗ MON Prohibit CAM
0001 Unit:01 00001
Blinking
MON CAM
0032 Unit:01 >00512