Filter
Top Products
55
■ Operation Start (Login)
1. Turn on the power switches of all system components.
2. Turn on the power of system controller. (Refer to the
Operating Instructions.)
The OPERATE indicator will light up, and the following
message will appear on the LCD.
Note: Wait unitl the following display appears on the LCD.
3. Enter the ID number by pressing the numeric buttons.
Then, press the CAM (SET) button. "PWD" will appear
on the LCD.
Note: When you have entered a wrong ID number,
press the CLEAR button.
4. Enter the password by pressing the numeric butons.
5. Press the CAM (SET) button.
When the password is correct, "OK" will apear for 2
seconds on the LCD.
Note: When the password is wrong, "NG" will appear
for 2 seconds on the LCD. In this case, retry the
login procedure.
Login and Logout
Note: If you perform the login procedure after resetting the
CPU unit or turning on the power of CPU unit, the LCD
display may return to Step 2. In this case, wait for
approx. 5 minutes until the CPU unit has been started
up. Then, retry the login procedure.
■
Operation End (Logout)
You need to log out of the system:
• When leaving the controller
• When system access is no longer required
1. During the login status, press the MON LOCK/LOGOUT
button while holding down the SHIFT button.
2. You will log out of the system, and the LCD display will
return to the login standby display.
■
ID Display Function
You can check the following on the LCD. (Refer to p. 82 for
how to display.)
• Operator ID
• Controller ID
• System version
ID:
Unit:01
ID:12345
PWD:
ID:12345
PWD:∗∗∗∗∗
MON PWD:OK CAM
Unit:01
ID:
Unit:01
ID:12345
PWD:NG
Connecting to
Main CPU ...