Panasonic WJ-MPU955A Home Security System User Manual


 
47
SNTP section
Note: This section should not be changed.
This section allows changes to Simple Network Time Protocol parameters, if SNTP is implemented.
[SNTP]
***{ This section is optional. It is not required unless }
***{ System defaults are not acceptable. Delete the }
***{ single asterisks below to make this section active. }
***{ This section lists user-defined client SNTP values, }
***{ sync rates and an external server address. }
***{ }
***{ Format: (VALUES INTERNAL TO THIS UNIT) }
***{ ClientMode=<mode> (act as an SNTP client) }
***{ modes: 0 - Internal (default) }
***{ 1 - Unicast }
***{ 2 - Anycast }
***{ 3 - Broadcast }
***{ ServerMode=<mode> (to expose its timestamp to }
***{ other units) }
***{ modes: 0 - Off }
***{ 1 - On (default) }
***{ InternalFrequency=<time frequency of sync (secs)> }
***{ -default is 600 sec (10 min) }
***{ }
***{ (VALUES FOR EXTERNAL CONNECTION) }
***{ NTPServerIPA=<IPA> of SNTP server }
***{ -for Unicast mode only; optional for }
***{ modes 0,2,3. }
***{ ExternalFrequency=<time frequency of sync (secs)> }
***{ -default is 18000 sec (5 hrs) }
***{ TZOffset=<hour> time zone offset from GMT }
***{ (+,-12 in integer values) }
***{ DaylightSaving=<on/off> (applies for the local }
***{ time zone) }
***{ on/off: 0 - off }
***{ 1 - on }
*ClientMode=1
*ServerMode=1
*InternalFrequency=600
*NTPServerIPA=192.168.200.XXX
*ExternalFrequency=18000
*TZOffset=5
*DaylightSaving=1
ERRORP section
Note: This section should not be changed.
This section allows changes to Error Log level.
[ERRORP]
ErrorLevel=3