Filter
Top Products
136 • Chapter 7 Application Programming DMC-3425
Formatting Messages
String variables can be formatted using the specifier, {Sn} where n is the number of characters, 1 thru
6. For example:
MG STR {S3}
This statement returns 3 characters of the string variable named STR.
Numeric data may be formatted using the {Fn.m} expression following the completed MG statement.
{$n.m} formats data in HEX instead of decimal. The actual numerical value will be formatted with n
characters to the left of the decimal and m characters to the right of the decimal. Leading zeros will be
used to display specified format.
For example::
MG "The Final Value is", RESULT {F5.2}
If the value of the variable RESULT is equal to 4.1, this statement returns the following:
The Final Value is 00004.10
If the value of the variable RESULT is equal to 999999.999, the above message statement returns the
following:
The Final Value is 99999.99
The message command normally sends a carriage return and line feed following the statement. The
carriage return and the line feed may be suppressed by sending {N} at the end of the statement. This is
useful when a text string needs to surround a numeric value.
Example:
#A
JG 50000;BGA;ASA
MG "The Speed is", _TVA {F5.1} {N}
MG "counts/sec"
EN
When #A is executed, the above example will appear on the screen as:
The speed is 50000 counts/sec
Using the MG Command to Configure Terminals
The MG command can be used to configure a terminal. Any ASCII character can be sent by using the
format {^n} where n is any integer between 1 and 255.
Example:
MG {^07} {^255}
sends the ASCII characters represented by 7 and 255 to the bus.