Shipping Bracket and Jig
AdeptSix 300CR Robot Instruction Handbook, Rev. A 37
3.3 Shipping Bracket and Jig
The robot is provided with a shipping bracket and jig at points A and B. See Figure 3-3 on
page 38 for details.
• The shipping bracket and jig are painted yellow.
• The number of hexagon socket head cap screws are: A: M6 X 2, B: M5 X 2.
• To prevent the jigs from damaging the paint of the robot, the resin washers are
inserted between the robot and the jigs.
NOTE: Before turning on the power, make sure that the robot is securely
mounted to its mounting base and that the shipping bracket and jig have
been removed. Then store the shipping bracket and jig for future use (in
the event that the robot must be moved again).
NOTE: Remove the protective covers from the 1BC and 2BC connectors
prior to installing the power and signal interconnect cables.
3.4 Installing Cover Bolts
After mounting the robot, remove the shipping bolts and jigs that were attached when
using the crane, and insert the cover bolts. When transporting the robot again, replace
them with the shipping bolts and jigs. Figure 3-3 illustrates the procedure for installing
the cover bolts
