Chapter 3 - Robot Installation
34 AdeptSix 300CR Robot Instruction Handbook, Rev. A
3.2 Transporting Method
Using the Crane
As a rule, a crane should be used to remove the robot from its package and to move the
robot into position. The robot should be lifted using wire slings threaded through the
attached eyebolts. Make sure the robot is fixed with jigs before transporting, and lift it into
the position shown in Figure 3-1 on page 35. Points A and B in Figure 3-1 identify the
locations of the shipping bracket and jig.
WARNING: When mounting the robot on the ceiling or
wall, the base section must have sufficient strength and
rigidity to support the weight of the robot. Also, it is
necessary to consider countermeasures to prevent the
robot from falling. Failure to observe these warnings may
result in injury or damage.
WARNING: Do not install or operate a robot that is
damaged or lacking parts. Failure to observe this caution
may cause injury or damage.
CAUTION: Before turning on the power, make sure that
the shipping bracket and jig have been removed. Failure to
observe this caution may result in damage to the gear
train, motors, and other key system components.
