Filter
Top Products
16–1
SECTION 16
Output Device Programming
(
✱
80 Menu Mode)
••••••••••••••••••••••••••••••••••••••••••••••••••
In This Section
♦
Programming Options Defined
♦
Programming Output Devices
••••••••••••••••••••••••••••••••••••••••••••••••••
Programming Options Defined
The following definitions will help you understand the programming of output devices when
using
✱
80 (this section) and
✱
81 (the Zone List section that follows). The options used to start
and stop these devices are described below, followed by the actual screen prompts and
available entries. We recommend that you first fill out the
Output Relays Worksheet for
Fields
✱
80 and
✱
81
in the separate Programming Form prior to programming.
Relays and output devices are not recommended for life safety applications.
The letter(s) in parentheses after each function described below, such as (A) after ACTION,
are those that appear in the various summary displays of programmed data during
programming.
ACTION (A) The "ACTION" of the relay is how the relay will respond when it is
activated by the "START" programming. You may want the relay to
activate momentarily, to pulse on and off continuously, or to remain
activated until some other event occurs to stop it. There are four different
choices of actions:
• ACTIVATE for 2 SECONDS and then reset.
• ACTIVATE and REMAIN ACTIVATED until stopped by some other
event.
• PULSE ON and OFF until stopped by some other event.
• NOT USED when the relay is not used.
START (STT) The "START" programming determines when and under what conditions
the relay will be activated. The following START options are available
:
1. EVENT (EV) is the condition (alarm, fault, trouble) that must occur to a
zone or group of zones (zone list) in order to activate the relay. These
conditions apply only when a zone list is used. The different choices for
"EVENT" are listed below and in the “Programming Output Devices”
paragraph that follows.
• ALARM Relay action begins upon any alarm in an assigned zone in
the zone list.
• FAULT Relay action begins upon any opening or short in an assigned
zone in the zone list.