Filter
Top Products
Section 15 - Zone Programming
15–7
10 INPUT S/N: L
A022-4064 1
Note:
The [A] and [B] keys
may be used to move the
cursor to the right (A) or left
(B) within the serial number
field, thus allowing you to
correct any entry errors that
may have been made.
Serial Number entry and Loop Number entry.
Used only when enrolling wireless transmitters.
a.
Transmit an open and close sequence. If you are using a button-
type transmitter, press and release the button;
OR
b.
Manually enter the 7-digit serial number printed on the label of
the transmitter, using the alpha display keypad;
OR
c.
To copy the serial number previously enrolled (used when
programming a transmitter with several input loops), simply
press key [C].
The cursor then moves to the “L.” You can edit the loop number, if
necessary. When the loop number is acceptable, press [
✱
].
10 XMIT TO CONFIRM
PRESS
✱
TO SKIP
The prompt to confirm appears.
This prompt appears only if you
answered “Yes” to the SET TO CONFIRM? prompt (the first
prompt after entering this field
✱
58)
previously. To confirm,
activate the loop input or button that corresponds to this zone.
The system checks for a duplicate. If a duplicate exists, a long
error beep sounds.
If a duplicate serial/loop number combination is found, the
keypad emits a single long beep, and displays the serial number
along with a “?” for the loop number, allowing you to re-enter the
correct loop number.
Press [#] to back up and re-enter the serial and/or loop number.
If the serial/loop number combination transmitted does not
match the serial and loop number entered, a display similar to the
one below appears.
Keyd A022-4063
1
Rcvd A022-4064 1
If so, activate the transmitter’s loop input or button one or more
times.
If a match is still not obtained (i.e., summary display does not
appear), press the [#] key twice and enter the correct loop input or,
if correct, press [#] again and then enter the correct serial number.
Zn ZT RC In:
L
11 00
10 RF:
-
Note that when editin
g
, an “s”
next to the loop number
indicates that the
transmitter’s serial number
has been enrolled.
If the serial number transmitted matches the serial number
entered, the keypad beeps 3 times and advances to the Summary
display of the next zone to be programmed.
NOTE: Following the successful enrollment of each wireless device, remove ONE of the
serial number labels from the device and affix it in the appropriate column on the
ENROLLED TRANSMITTERS worksheet of the Programming Form. Then enter the other
information (zone number, zone type, loop number, etc.) relevant to that device. This
information will be useful if any troubleshooting is needed later on. The installer may want
to consider leaving this worksheet at the site (in the panel cabinet).