Filter
Top Products
Changing Needle
[_ Raise the needle by pressing the up/down needle
button and lower the presser foot,,
Turn off the power switch.,
Loosen the needle clamp screw by turning it
counterclockwise.
Remove the needle from the clamp.
[] Insert the new needle into the needle clamp with the flat
side to the rear.
When inserting the needle into the clamp, push it up as
far as it will go. Tighten the clamp screw firmly by
turning it clockwise.
[] To check for a good needle, put the flat side of the
needle onto something fiat (the needle plate, glass,
etc.). The gap between the needle and the flat surface
should be consistent° Never use a bent or blunt needle.
(_ Needle clamp screw
(_) Pin
® Needle clamp
[]
[]
[]
r/-7-7-7-// f / E /
k ...............................
To Remove and Attach the Presser Foot
[] Press the red button on the back of the foot holder,. The
presser foot wilt drop off,
[] Place the selected presser foot so the pin on the foot
lies just under the groove of the foot holder, Lower the
presser bar to lock the foot in place,
0 Red button
(_) Groove
® Pin
To Remove and Attach the Foot Holder
[] To Remove:
Remove the thumb screw by turning the screw counter-
clockwise with the screwdriver.
[] To Attach:
Match the hole in the foot holder with the threaded hole
in the presser bar,
Fit the thumb screw into the holeo
Tighten the screw by turning clockwise.
O Thumb screw
(_) Foot holder
® Presser bar
[]
,*.1%t
[]
@___/
[] []
®
26