Filter
Top Products
SECTION V CARE OF YOUR MACHINE
Clean the Hook Race and Feed Dogs
(_) Screw driver
Q Set screw
® Needle plate
O Lint brush
® Hook race
® Bobbin holder
O Feed dogs
O Soft, dry cloth
Press the needle Up/down needle position button to raise
the needle, then unplug the sewing machine.
Do not dismantle the machine other than explained on this
page.
Remove the cover plate by sliding the hook cover plate
release button to the right. Take out the bobbin. Brush out
dust and lint..(You may also use a vacuum cleaner°)
[] Remove the set screw on the left hand side of the
needle plate with the screwdriver supplied with the
machine. Remove the needle plate.
[] Take out the bobbin. Lift up the bobbin holder and
remove it,.
[] Clean the hook with a soft dry cloth°
[] Clean the feed dogs and hook race with the lint brush°
[] Clean the center of the hook race with a dry cloth.
You may also use a vacum cleaner.
Assemble the Hook Race
O Bobbin holder
® Stopper
® Knob
@ Needle plate guide pins
@ Screwdriver
® Guide holes
[] Insert the bobbin holder so that the knob fits next to the
stopper in the hook race.
[] Insert the bobbin.
[] Attach the needle plate with screw_
After cleaning the machine, make sure the needle
and presser foot are attached,,
f
[]
[]
[]
[]
[]
d
[]
i
[]
®
'1t 8