Filter
Top Products
ilVIPORTANT SAFETY iNSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use°
Read all instructions before using this sewing machine,,
DAN G E R -- To reduce the risk of electric shock:
1, This sewing machine should never be left unattended when plugged inoAlways unplug this sewing machine from the
electric outlet immediately after using and before cleaning,
2. Always unplug before replacing a sewing machine bulb, Replace bulb with same type rated 3 Watts.,
3. Do not reach for a sewing machine that has fallen into water. Unplug immediately,,
4, Do not place or store this sewing machine where it can fall or be pulled into a tub or sink,. Do not place or drop it into water
or other liquid.
WARNJNG - To reduce the risk of burns, fire, electric shock, or injury to persons:
1 Do not allow this sewing machine to be used as a toy..Close attention is necessary when this sewing machine is used by
or near children.
2. Use this sewing machine only for its intended use as described in this owneCs manual.
Use only attachments recommended by the manufacturer as contained in this owner's manual.
3. Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into water.
Return this sewing machine to the nearest Sears store or service center for examination, repair, electrical or mechanical
adjustment,.
4. Never operate this sewing machine with any air opening blocked. Keep ventilation openings of this sewing machine and
foot controller free from accumulation of lint, dust and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
8° To disconnect, turn all controls to the off ("0") position, then remove plug from out_et.
9. Do not unplug by pulling on cord.To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around the sewing machine needle.
t 1_Always use the proper needle plate..The wrong plate can cause the needle to break.
12. Do not use bent needles
13. Do not pull or push fabric while stitching. It may deflect the needEecausing it to break.
'14.Switch this sewing machine off (" O") when making any adjustment in the needle area, such as threading the needle,
changing the needle, threading the bobbin or changing the presser foot, and the like.
15 Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any
other adjustments mentioned in this owner's manual
SAVE THESE INSTRUCT ONS
When using your sewing machine for the first few times, place a waste fabric under the presser foot and run
the machine without thread for a few minutes. Wipe away any oil which may appear,
]