Filter
Top Products
SECTION ii. GETTING READY TO SEW
Connecting Machine to Power Supply
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power,
* Turn off the power switch (_,. Insert the foot control plug
(_ and the machine plug (_, into the machine. Insert the
power supply ptug (_ into the wall in this order:
(_ Foot control plug
(_) Machine plug
(_ Power supply plug
(_ Power switch
(_) Power supply cord
(_ Foot control
For Your Safety
* While in operation, always keep your eyes on the
sewing area. Do not touch any moving parts such as the
thread take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
-- When leaving the machine unattended.
-- When attaching or removing parts.
-- When cleaning the machine..
* Do not place anything on the foot control when not
sewing
Operating Instructions
"For appliances with a polarized plug (one blade wider than
the other)
To reduce the risk of efectric shock, this plug is intended to
fit in a polarized ourlet only one way, tf it does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician to install the power outlet. Do not
modify the plug in any way"
"Foot Controller Model YC-542 for use with Sewing
Machine Model 385.19365XXX"
XXX - represents numbers 000 through 999,
,J
Electronic Sewing Speed Control
o Speed control lever
Sewing speed can be controlled by adjusting the speed
contro_ lever 1_,
To increase the maximum sewing speed, slide the lever
to the right
To decrease the maximum sewing speed, slide the lever
to the }eft.
(_ Speed setting lever
. Foot control
Sewing speed can be varied by the foot control
The harder you press on the foot control, the faster the
machine runs,
10