Filter
Top Products
Positioning the telescoping thread guide bar
(_ Thread guide
Telescoping thread guide bar
Stoppers
Spool pin
Pull the telescoping thread guide bar _ up as far as it will
go.
Turn the thread guide bar _ until it clicks into position.
Thread guides _ should stop directly above the
spool pins (_.
NOTE
Make sure the two stoppers _ on the thread guide shaft,
as shown, are set in at the correct position.
Attaching the spool cap and net
Spool holder
Spool pin
Spool cap
Slit
When you use a small thread spool, remove the spool
holder (_ from the spool pin @. Then place the spool with
its slit _ side up, and put spool cap _ on top.
Spool pin
Net
If the thread slips down from the spool during threading
and / or sewing, put a net (_ on the spool as illustrated to
prevent jamming. The nets are supplied with the machine.
Raising or lowering the presser foot
(_ Presser foot lifter
Presser foot
By raising or lowering the presser foot lifter (_, the presser
foot _ goes up and down.
While in operation, keep the presser foot _ lowered except
for threading the machine or test running without thread.
NOTE
Thread tension will be released when the presser foot
lifter is raised.
12
t
m
t
=