Twin Needle Sewing
Some of the utility stitches and decorative stitches can
be sewn with a twin needle.
Replace the needle with the twin needle supplied with
the standard accessories.
CAUTION:
Turn the power switch off or press the lockout key
before changing the needle.
Do not use twin needles other than the one included
in the standard accessories, otherwise the needle
may hit the needle plate, foot or hook and break.
q Lockout key
Insert the additional spool pin into the hole under the top
cover.
Place a spool of thread and the felt on the additional
spool pin and the spool stand (refer to page 12).
w Additional spool pin
Draw both threads from the spools and pass them
through the threading points from z to v.
Slip the thread A through the needle bar thread guide b,
then pass through points n and m as illustrated.
Thread the thread B through the front hole of needle bar
thread guide b, then pass it through the needle hole ,.
Make sure that the two strands of thread from the spools
do not get tangled.
NOTE:
•Threadingfrompointsz to v is the same as for a
single needle (refer to page 15).
•Theneedlethreadercannotbeusedwiththetwin
needle.
Press the twin needle key and select the desired pattern.
Patterns not suitable for twin needle sewing cannot be
selected (pattern selection keys are grayed out).
Buttonholes, specialty stitches and monogram cannot be
selected.
e Twin needle key
NOTE:
•Whenyousewpatternswiththetwinneedle,test
the stitches first before you sew on the garment.
•UsethezigzagfootAorsatinstitchfootFfortwin
needle sewing.
•Usethethreads#60orner.
•Whenchangingthesewingdirection,raisethe
needle and presser foot then turn the fabric (foot
up for pivoting option is not available when the twin
needle is selected).
•Usethethreadcutteronthefaceplatewhen
cutting threads.
After twin needle sewing is finished, press the twin
needle key and the warning message will appear.
Press the OK key and replace the twin needle with a
single needle.
e
q
v
w
z
x
b
n
m
A B
,
c
63