Janome 15000 Sewing Machine User Manual


  Open as PDF
of 184
 
If you wish to use the foot control, pull out the cord from
the foot control and insert the pin connector into the jack
on the machine (see page 6).
z First make sure the power switch q is off.
x Insert the machine plug w of the power supply cord
into the power inlet e.
c Draw out the cord from the foot control and insert the
pin connector y into the jack u on the machine.
v Insert the power supply plug r into the wall outlet t,
and turn the power switch on.
q Power switch
w Machine plug
e Power inlet
r Power supply plug
t Wall outlet
y Pin connector
u Jack
NOTE:
•Thestart/stopbuttondoesnotworkwhenthefoot
control is connected.
•Thefootcontrolcannotbeusedintheembroidery
mode.
•Donotdepressthethreadcutterswitchwhen
inserting the pin connector y into the jack u.
Connecting the Power Supply
z First make sure the power switch q is off.
x Insert the machine plug w of the power supply cord
into the power inlet e.
c Insert the power supply plug r into the wall outlet t,
and turn the power switch q on.
q Power switch
w Machine plug
e Power inlet
r Power supply plug
t Wall outlet
NOTE:
Makesuretousethepowercablethatcamewiththe
machine.
If you turn off the power switch, wait for 5 seconds
beforeturningitonagain.
WARNING:
While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.
q
w
e
Operating Instructions:
Thesymbol“O”onaswitchindicatesthe“off”positionof
the switch.
Foot controller Model 21390 is for use with sewing
machine MC15000.
For the U.S.A. and Canada only
Polarizedplug(onebladewiderthantheother):
Toreducetheriskofelectricshock,thisplugisintended
to fit in a polarized outlet only one way. If it does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
y
u
r
t
e
t
r
w
q
8
 previous next