Janome 15000 Sewing Machine User Manual


 
If you use a slippery thread such as monofilament
transparent thread, put the net on the spool of thread
to prevent the thread from slipping off the spool and
jamming around the spool pin.
Setting the Spool of Thread
Openthetopcover.
Lift up the spool pin. Place the spool of thread on the
spool pin.
Attach the large spool holder, and press it firmly against
the spool of thread.
NOTE:
Use the small spool holder to hold narrow or small
spools of thread.
Winding the Bobbin
Removing the bobbin
CAUTION:
Press the lockout key or turn the power switch off.
zSlidethehookcoverreleasebuttonq to the right,
and remove the hook cover plate w.
qHookcoverreleasebutton
w Hook cover plate
xRemovethebobbinfromthebobbinholder.
NOTE:
Usetheplasticbobbinsforhorizontalhookmarked
witha“J”.Usingotherbobbins,suchaspre-wound
paperbobbins,maycausestitchingproblemsand/
ordamagetothebobbinholder.
x
z
r
w
q
e
Additional spool pin
Use the additional spool pin when you need to wind a
bobbinwithoutunthreadingthemachinewhileworkingon
a sewing project (refer to page 109).
Set the spool stand q under the additional spool pin w.
Insert the additional spool pin w into the hole e.
Place the felt r and a spool on the pin.
q Spool stand
w Additional spool pin
e Hole for additional spool pin
r Felt
NOTE:
Theadditionalspoolpinisalsousedfortwinneedle
sewing.
q
w
12