Janome 15000 Sewing Machine User Manual


  Open as PDF
of 184
 
146
NOTE:
•Use the same thread for the bobbin as the needle
thread.
•Adjustthefootheightw if necessary.
•Setthelowbobbinthreadwarninglevele to 3 or 4.
•AcuFildesignscannotbeopenedintheEditing
mode.
•Usethepurpletipneedle.
Sewing AcuFil design pattern
InserttheUSBashdrivethatcontainstheAcuFildesign
file into the USB port of the machine.
Turn on the machine and go to Open File in the
embroidery mode.
Press the icon key of the desired file and the selected
AcuFil design will open.
Turn the one stitch stop r option “ON”.
Attach hoop ASQ22 to the machine and sew the first
section.
Setting quilt layers in hoop ASQ22
Position the quilt layers on hoop ASQ22. Place the AcuFil
template (with the arrow mark facing up) on the quilt and
adjust the position of the quilt aligning the centerlines of
the quilt and AcuFil template.
Set the quilt layers in the hoop and press down the AcuFil
template. While pressing the AcuFil template close to the
outer frame, snap the magnetic clamps onto the hoop to
fasten the quilt layers to the hoop.
Remove pins and basting stitches from the hooped area.
Then rehoop the quilt layers and sew the next section.
Repeat these steps. Sew the center section first, then
neighboring sections one by one outward.
NOTE:
•Provideawidespacearoundthemachine.
Prevent the free end of the quilt layers from
hanging down from the sewing surface. Use of the
extra wide table is recommended.
•Ifyouneedtosewthequiltupsidedown,pressthe
turnover key q to flip the design pattern.
•Makesuretoraisetheneedlebypressingthe
needle up/down button before moving the carriage
to the home position.
w
e
q
r
 previous next