Filter
Top Products
47
Cloth Guide Position window will appear.
Press the or the key to move the
Cloth Guide to the desired position.
NOTES:
• The distance of the Cloth Guide edge from
the center needle position is shown in
millimeter or inch.
• You may set the Cloth Guide Position from
–2 mm to 40 mm (–1/8˝ to 1 1/2˝).
• From -2 mm to10 mm, you may change the
setting by 1 mm and from 10 mm to 40 mm,
you may change the setting by 5 mm each
time you press the or the key.
4
Default key: When you press the key
the setting returns to the default (the same
settings as when you purchased the
machine, which is 15 mm,
5
Cancel key: When you press key,
the Cloth Guide Position window will close
and the setting remains unchanged.
6
OK key: When you press the key, your
settings are registered.
Overcasting with the Cloth Guide
Select Pattern 10 and use Overedge Foot C.
Set the Cloth Guide position at 2 mm (1/16˝)
and sew.
NOTE:
• When using the Cloth Guide, if you select
other patterns, the Visual Touch Screen
shows “Remove the Cloth Guide”. Press
the key so that the carriage returns to
its home position. Then you can safely
remove the Cloth Guide.
Remove the Cloth Guide.
Cancel
OK
15 mm
DefaultCancel
OK
Cloth Guide position
654
Default
Cancel
OK
OK