Filter
Top Products
16
5
5 Press the Auto Threader Button again.
The threader goes up automatically and
pulls the thread out through the needle
eye. Pull the loop of thread to the back.
3
2
1
NOTES:
• The Automatic Needle Threader works
well on the needles Nos.11-14, sewing
threads Nos.60-120 and Janome
embroidery threads.
• Thick threads, Nos. 20 and 30, cannot be
used.
CAUTION:
• To use the Automatic Needle Threader
properly, always make sure to pay
attention the following instructions.
• Do not turn the handwheel while the
Automatic Needle Threader is in the
lowered position to prevent it from
damage.
• Do not touch the Automatic Needle
Threader while it is moving.
• If the Automatic Needle Threader is
locked by accidentally turning the
handwheel, release it as follows:
1. Carefully turn the Handwheel to move
the needle up or down a little, so that it
frees the Automatic Needle Threader.
2. Press the Auto Needle Threader Button
to restore the Automatic Needle Threader
to the up position.
1 Handwheel
2 Auto Needle Threader Button
• If the Automatic Needle Threader will not
return to the up position by pressing the
Auto Needle Threader Button, correct it
as follows:
1. Turn the Power Switch off.
2. Open the Face Plate. Beware of the hot
bulb.
3. Turn the Threader Shaft counterclockwise
to release the hook from the needle eye.
4. Turn the Power Switch on and the
Automatic Needle Threader will return to
the up position.
5. Close the Face Plate.
1 Power Switch
2 Face Plate
3 Threader Shaft
1
2