Filter
Top Products
173
1
1
2
3
4
5
6
7
8
2
3
4
3
4
5
6
7
8
Cleaning the Hook Race and Feed
Dog
Press the Up/Down Needle Button to raise
the needle, then unplug the sewing
machine.
NOTE:
• Do not dismantle the machine other
than what is explained on this page.
1. Remove the Set Screw on the left
hand side of the needle plate with the
screwdriver supplied with the machine.
Remove the Needle Plate.
2. Take out the bobbin. Lift up the
Bobbin Holder and remove it.
3. Clean the Bobbin Holder with a Lint
Brush.
4. Clean the Feed Dog and Hook Race
with the Lint Brush.
5. Clean the Hook Race with a Soft Dry
Cloth.
(You may also use a vacuum cleaner.)
1Set Screw
2 Needle Plate
3 Bobbin Holder
4 Lint Brush
5 Feed Dog
6 Hook Race
7 Soft Dry Cloth
Assemble the hook race
6. Insert the Bobbin Holder so that the
Knob fits next to the Stopper in the
hook race.
7. Insert the bobbin.
8. Reattach the needle plate, aligning the
Guide Holes on the needle plate with
the Needle Plate Guide Pins and
tighten the screw.
8 Bobbin Holder
9 Knob
10 Stopper
11 Guide Holes
12 Needle Plate Guide Pins
NOTE:
• After cleaning the machine, make
sure the needle and presser foot are
attached.
9
10
12
11