Filter
Top Products
WIRELESS NETWORK IP CAMERA User’s Guide
75
By Using Hyper Terminal (Advanced Users only)
① Execute Hyper Terminal as
described in Chapter “4.3.1
Configuring Hyper Terminal”
② Supply the power to the Wireless
Network IP Camera.
③ After a while, the count down
starts with the message
“Press 'p' key to stop auto-boot or
Load-Default-Button under the
NetCam for 3 seconds...”
.At this time, press the ‘p’ key. Then,
[Wireless Network IP Camera Boot]
prompt shows like the right side
image.
④ When you enter ‘w’, Administrator ID & password reset as factory default ‘admin.’
Factory default setting
Administrator ID: admin
Administrator Password: admin
Guest ID: guest
Guest Password: guest
IP Address: 192.168.1.221
Subnet Mask Address: 255.255.255.0
Gateway Address: 192.168.1.1
Server IP Address: 192.168.1.200
Compression Rate: Level 1
Image Size: QVGA
NOTE
Reinstating the original default settings will cause all parameters (Including IP address) to reset.