Filter
Top Products
WIRELESS NETWORK IP CAMERA User’s Guide
21
the network on booting sequence. For more information on Wireless Network IP Camera upgrade,
refer to “E. Updating Wireless Network IP Camera’s Newly Upgraded Program”.
Gateway inet (g) is the gateway address of the Network Camera
7. Type ‘c’ to change the network configuration in [Boot] prompt. If you type ‘c’,, the Wireless
Network IP Camera shows you the information you can change and the current assigned values.
You can change as the following figure.
8. When you terminate the Hyper-Terminal program after changing the network configuration,
Hyper-Terminal asks you whether to save the session. If you save the session, you can re-use
the hyper-terminal. To re-use the session you saved, click Start --> Programs --> Accessories --
> Communications --> HyperTerminal --> Wireless Network IP Camera.. ht in the case of
Windows 2000.