Filter
Top Products
WIRELESS NETWORK IP CAMERA User’s Guide
20
6. You can see Network Configuration while [Boot] prompt is running by pressing ‘p’ key again.
Here, inet on ethernet (e), host inet (h) and gateway inet (g) values are network configuration values.
You should change these values in most cases. If you don’t know what values you should assign,
contact the network administrator.
Inet on ethernet (e) is the IP address and Subnet Mask address of the Wireless Network IP Camera.
IP address and Subnet Mask addresses are separated by colon (:). For example, IP address is
represented by decimal numbers delimited by dots (.), e.g., ‘192.168.1.27’. Hexadecimal numbers,
e.g., ‘ffffff00’ in the case of ‘255.255.255.0,’ represent the Subnet Mask address. Note that the
numbers in the Subnet Mask value are not delimited by dots. See the example in the above picture.
Host inet (h) is the address to which Wireless Network IP Camera tries to connect to upgrade its
firmware program in flash memory. The Wireless Network IP Camera first searches for this host on