Filter
Top Products
WIRELESS NETWORK IP CAMERA User’s Guide
39
Wireless Configuration
This screen is used to configure wireless settings to match your access pointer for a wireless network
connection.
Wireless Setup
1. Use the Connection Mode to determine the type of wireless communication for the Wireless
Network IP Camera. There are two choices: Infrastructure Mode and Ad-hoc Mode. The default
setting for the Connection Mode is Infrastructure Mode.
2. Set the Service Area Name (SSID) as per the access point setting to which the user wants to
connect.
3. The channel is set to channel 1 as a default. In Infrastructure Mode the camera will automatically
find the Access Point. The channel only needs to be set in Ad-hoc mode.
4. The default setting for the “Tx rate” is Auto; however, it can be set to 5.5. or 11 mbps if required.
NOTE
Keep in mind the slide switch on the rear panel must be positioned to LAN-WAN or WLAN for the
wireless communication to take effect.