Filter
Top Products
Audio Command Center Series Manual — P/N 51889:E1 6/8/2010 31
Getting Started Product Description
• Record any new voice messages as described in Section 4, ”Operating Instructions” on page
63.
• Program the FACP to operate with the ACC-25/50ZS/T
Enable the ACS serial link or ANN-BUS serial link.
Assign audio zones where applicable (see Section D, ”Programmed Activation by FACP”
on page 105.)
Assign message numbers (1 - 5) where applicable (see Section D, ”Programmed Activation
by FACP” on page 105).
1.7.4 ACC-25/50ZS & ACC-25/50ZST, Requiring Greater Than 50
Watts But Less Than 150 Watts
• Install backboxes and circuit boards as described in Section 3, ”Installation” on page 42.
• Configure the ACC-25/50ZS/T for Single Zone operation using DIP switch S3 switches 1, 2
and 3 on the ACC-MCB motherboard. Refer to Section 2, ”Field Programming” on page 32.
• Configure the ACC-ZPM Zone Page Module DIP switch S1 switches 1, 2 and 3 for operation
with the FACP. Refer to Section 2, ”Field Programming” on page 32 and Section 5,
”Application Examples” on page 80.
• Record any new voice messages as described in Section 4, ”Operating Instructions” on page
63.
• Program the FACP to operate with the ACC-25/50ZS/T
Enable the ACS serial link or ANN-BUS serial link.
Assign audio zones where applicable (see Section D, ”Programmed Activation by FACP”
on page 105).
Assign message numbers (1 - 5) where applicable (refer to Section D, ”Programmed
Activation by FACP” on page 105).
If Remote FFT annunciation is required, assign ACC address as described in Section D,
”Programmed Activation by FACP” on page 105.
• Connect Audio Riser and ACC Control Serial Link cabling between the ACC-25/50ZS(T) and
the ACC-25/50DAZS.