Filter
Top Products
114 Audio Command Center Series Manual — P/N 51889:E1 6/8/2010
Programmed Activation by FACP MS-9600, MS-9200UDLS and MS-9200UD
Pressing 3 while viewing Zone Setup Screen #3 will cause the following screen to be displayed:
Press the down arrow key until the following screen is displayed.
The default setting is No Message for each speaker circuit. In the screen shown above, Z32 is the
zone dedicated for all speaker circuits. To change from No Message, press 3 to display the follow-
ing screens:
Select the message (Message 1 through Message 5) by pressing the number corresponding to the
desired message. After the selection is made, the display will return to the screen displaying Z32
which will have changed from No Message to the selected message.
Repeat the procedure outlined above for each speaker zone (Z32 through Z56) and then exit Pro-
gramming by pressing the Escape (ESC) key to save the programming changes. Test the system to
ensure proper operation.
ZONE MESSAGE
1=Z00 NO MESSAGE
2=Z01 NO MESSAGE
3=Z02 NO MESSAGE
ZONE MESSAGE
1=Z30 NO MESSAGE
2=Z31 NO MESSAGE
3=Z32 NO MESSAGE
ZONE MESSAGE
1=NO MESSAGE
2=MESSAGE 1
3=MESSAGE 2
ZONE MESSAGE
1=MESSAGE 3
2=MESSAGE 4
3=MESSAGE 5