Filter
Top Products
DMC-1700/1800 Chapter 2 Getting Started • 23
Once in the Galil Registry, click New Controller under Non-PnP Tools. Select the appropriate
controller from the pull down menu and adjust the timeout as seen fit. Click Next to continue.
The registry information for the DMC-1700 card will show a default address of 1000. This
information should be changed as necessary to reflect any changes to the controller’s address jumpers.
Hardware interrupts may also be set in the registry, although for initial communication these are not
necessary. The default interrupt selection is “None”.
Once the appropriate Registry information has been entered, Select OK and close the registry window.
After rebooting the computer, communication to the DMC-1700 card can be established. Reopen one
of the communication programs and select the controller from the registry list.