Filter
Top Products
EQUIPMENT CHECK-OUT AND ADJUSTMENTS
6-4
February 1996
Part No. 004-3039-274
SCREEN 1
______________________________________________________________________________________
TOUCH THE UPPER LEFT POINT USING ONLY ONE FINGER
FINGER SHOULD BE PERPENDICULAR TO SCREEN
HOLD FINGER IN PLACE UNTIL YOU ARE INSTRUCTED TO REMOVE IT
Press ANY key to ABORT calibration
______________________________________________________________________________________
SCREEN 2
______________________________________________________________________________________
AFTER PRESSING UPPER LEFT, TOUCH THE LOWER RIGHT POINT USING
ONLY ONE FINGER
FINGER SHOULD BE PERPENDICULAR TO SCREEN
HOLD FINGER IN PLACE UNTIL YOU ARE INSTRUCTED TO REMOVE IT
Press ANY key to ABORT calibration
______________________________________________________________________________________
When the calibration is complete, the message
SF CAL Written, Calibration updated on Installed
SFKERN Driver , will be displayed.
c:\> prompt will display:
4. Initialize the CRT Console:
Reboot the system by pressing the RESET button on
the computer.
The Main Screen will then be displayed.
NOTE: if the Main Screen does not appear, check
the AUTOEXE.BAT file and make sure the drivers
are installed. If they are not, call for technical help
if you do not know how to install them.
6.5 AFTER SYSTEM CHECK-OUT
At this point, the E.F. Johnson CRT Console system
installation and checkout has been completed. If you
have any questions or problems, contact Technical Sup-
port, 1-800-328-3911. Be sure to complete and mail the
warranty cards for other manufacturer’s equipment, such
as the CRT monitor, printer, modem, etc. These can be
found at the back of the VR-CM50 Console Service Man-
ual, Volume 2.