Filter
Top Products
69
Installation/Set up
Viewing • Listening
and Operation
Recording
Setting up
Others
3) Enter the email address of the Administrator in “Sender email address.”
4) Click the “Save Settings” button.
5) Enter email addresses of up to 10 destinations in “Receiver email address 1”
to “Receiver email address 10.”
6) Click the “Save Settings” button.
7) Enter the mail title in “Subject” (default: TOSHIBA Network Camera).
If a check is added to “Camera Name automatically,” the camera name is set
automatically as the subject.
8) Enter your message in the “Message body.”
9) Select the number of attached images from the “Attach File” pull-down menu.
10) Select whether or not a mail should be sent in the following cases:
• “Send email when motion detected”
Check here to send a mail when a motion is detected.
• “Send email when external alarm detected”
Check here to send a mail when an external alarm is detected.
• “Send email when accumulator error caused”
Check here to send a mail when an error occurs in an SD memory card to
accumulate images.
• “Send notification email by accumulating time”
Check here to send a notification mail at 30-minute intervals up to the total
length of time (240 minutes) when starting accumulating image data in an
SD memory card.
30min, 60min, 90min, 120min, 150mim, 180min, 210min, 240min
11) When an error occurs in sending a mail, you can set up the re-sending
operation.
• Follow the setup procedures below:
11-1) Check “ON” of “In an email transmitting error, [ ] times resendings are
tried every [ ] minutes” (default: not marked).
11-2) Select the times of resending operation from the pull-down menu for the
first [ ] (default: 3).
11-3) Select the time interval of resending operation from the pull-down menu
for the second [ ] (default: 3).
12) Click the “Save Settings” button.
NOTE
●
POP3 is a protocol for receiving (retrieving) mail from the mailbox. However, these settings
will not result in received mail, for example, being deleted because the network camera
does not retrieve mail.
●
The mail function of the network camera does not support “SMTP Auth”.
●
The attached image data is in a format that ordinary mail client software can read.
IK-WB02-66-78 2004.10.21, 02:2469