Filter
Top Products
65
Installation/Set up
Viewing • Listening
and Operation
Recording
Setting up
Others
2) Click the “Save Settings” button.
● Setting the motion detection
1) Select one of the followings in “Motion Detect:”
Enable : To turn motion detection on.
Disable : To turn motion detection off.
(Default: Disable)
2) Select the “Sensitivity” level from the pull-down menu.
High : Generates an alarm upon detection even to the slightest
change in brightness.
Middle : Sensitivity is at a level between High and Low.
Low : Generates an alarm upon detection of significant changes in
brightness only.
(Default: Middle)
*
If an alarm is detected frequently when there are no abnormalities, reduce
the level of sensitivity.
3) Click the “Save Settings” button.
● Setting up EXT Control
1) Select “EXT” in “External Alarm Detect.”
2) Click the “Save Settings” button.
NOTE
●
For record settings at the time of alarm generation, refer to “Alarm Recording”
(➝ page.40) and “FTP by External Alarm/Motion Detection” (➝ page.46).
●
For record settings when the EXT Control is used, refer to “FTP by EXT
Control” (➝ page.48).
●
You can send an email at the time when an alarm is raised. For more information
about settings, refer to “Mail Settings” (➝ page. 68).
IK-WB02-61-65 2004.10.21, 13:4365