Filter
Top Products
88
Installation/Set up
Viewing • Listening
and Operation
Recording
Setting up
Others
Before Calling Service Personnel...
There is no IP
address of your
network camera
on The Camera
Finder’s Network
Camera List.
Cannot display a
browser from
Camera Finder.
The message,
“The page
cannot be
displayed,”
shows up, and
cannot login to
the camera even
if you start
Camera Finder.
Cannot login to
the camera even
though entering
the IP address of
the camera
directly to the
browser, and
“The page
cannot be
displayed” shows
up.
●
The power of the camera
is not turned on.
●
LAN cable is not
connected.
●
LAN cable is not
connected to the PC.
●
IP address of the PC is
not configured.
●
Installed directory of
browser is wrong.
●
The IP addresses of the
camera and your PC are
wrong.
●
Proxy has set to the
browser.
●
Turn on the power.
●
Connect the LAN cable of the camera to a hub or
router in the right way.
●
Be sure to turn on the power of the hub and router.
●
Connect the LAN cable to the PC in the right way.
●
Configure the IP address of your PC correctly.
(
→
page 15).
●
Assign the directory where you are going to install the
browser. Start Camera Finder and go to “View”/
“Customize”/“Default Browser.”
●
Set the correct IP address of the network camera.
●
Set the correct IP address of your PC.
●
When proxy is set to the browser, sometimes you may
not able to login. Change the setting which will not via
the IP address of the network camera from the proxy of
the browser, or the setting of host name which will not
via proxy.
Symptom Cause
How to Manage
See “The message, ‘The page cannot be displayed,’ shows up, and cannot login to the
camera even if you start Camera Finder.”
IK-WB02-88-94 2004.10.21, 02:4388