Filter
Top Products
49
Installation/Set up
Viewing • Listening
and Operation
Recording
Setting up
Others
■Image Accumulation to SD Memory Card
Configures whether or not to save image data on SD memory card when the camera
can not record image(s) on FTP server due to network problems. The accumulated
data is transferred to the FTP server when the line is restored.
1) Configure whether or not the Image Accumulation is active
●
Select “ON” to save image data on SD memory card. Select “OFF” if you do not
need to save image data on SD memory card.
2) Configure Restriction
●
Select an accumulation time from the pull-down menu. (1 to 24 [unit: hour], No
limit)
3) Configure Interval(s)
●
Configure recording cycle of accumulated images.
Enter a number to configure the interval.
NOTE
• Set “Image Accumulation” to “ON” before setting Interval(s).
4) Set up Re-transfer Trigger
●
You can select the timing to re-transfer accumulated images to the FTP server.
When Network Recovers: When the line is restored
When EXT Control is opened: When the contact of EXT Control is opened
5) Configure Re-transfer Interval
●
Configure the interval (unit: second) for re-transferring accumulated images.
●
Enter a number to configure the interval.
6) Configure settings for viewing FTP status
●
Select the interval in “Check FTP status (sec)” from the pull-down menu to try to
view the FTP status.
7) Click “Save Settings” button to save configured items
●
The changes are discarded.
NOTE
• You can perform formatting an SD memory card by clicking “Complete Format” or
“Quick Format” in the Admin settings (➝ page. 63).
• If the setting is made to record image data in an SD memory card at the time of
alarm generation (➝ page.40), the data is recorded to an SD memory card when
the alarm is raised regardless of ON/OFF setting in the “Image Accumulation.”
IK-WB02-47-54 2004.10.21, 02:1949