Filter
Top Products
5
Installation/Set up
Viewing • Listening
and Operation
Recording
Setting up
Others
Names and Features of Parts
Image sensors are embedded.
Protect the part from dust,
dirt and finger marks.
Image Pickup
Video-Out Jack
Connect a video monitor to the video
output jack.
Ethernet Port
Connect a LAN cable to the port.
A PoE compatible hub is also supported.
SD Card Slot
Insert an SD memory card.
Alarm Terminal
Connect an external
alarm device with the
terminal.
Audio-Out Jack
Connect an audio output device such
as a speaker with a built-in amplifier
to the audio output jack.
Audio-In Jack
Connect a microphone
to the audio input jack.
AC24V/DC12V Power Plug Terminal
Connect an AC24V or DC12V power plug to
the terminal.
●Front
●Top
●Rear
FOCUS LOCK
Focus ring
Adjust the back focus of a lens.
Focus Lock Screw
After adjusting the back focus, tighten the screw.
Reset Button
When the button is
pressed, all the set
values of the firmware
on the network camera
are reset to the default
settings (initial state).
(➝ page. 93)
Lens Mount
Install a CS mount lens.
Tripod Screw Hole
IK-WB02-02-06 2004.10.21, 01:495