Filter
Top Products
Decorative sewing
4:17
Create a new patchwork program
1. To create a new patchwork program, touch the ON icon to activate
the function and press OK. The Patchwork program icon will
change and will say prog pat (B).
2. You determine the length of the seam by test sewing and pressing
the Reverse sewing button. The seam is completed without being
tied off. The Prog pat icon will change again and say auto pat (C).
If you want to tie-off a programmed seam at the start and/or at the
end, make sure that the patchwork program is activated and then touch
the Tie-off icon (D) to open the tie-off program. Turn on the functions
you want to activate and press OK.
If you want to adjust the seam of your patchwork program, touch the
Auto pat icon (C). You will then see the length of your patchwork and
a + and - icon. Touch the + icon to increase the length of the seam. The
seam is increased in steps based on the set stitch length. If the stitch
length is set to 2 mm, the programmed seam increases in 2 mm steps.
The stitch length itself will not change.
Touch the - icon to reduce the length of the seam. The stitch length
will not change. The seam is decreased in steps based on the set stitch
length. If the stitch length is set to 2 mm, the programmed seam
decreases in 2 mm steps. The stitch length itself will not change. Touch
the Data Manager icon (A). A window will open allowing you to open,
save, save as or close a program. To turn the function off, touch the
Auto pat icon (C), and then ON. Confi rm with OK.
B
C
D
A