Filter
Top Products
Embroidery
5:24
Working steps
In the example below we want to connect two designs to each other
(see picture). This is a design that is included in your creative 2170.
1. While the machine is turned off, attach the embroidery unit and the
embroidery foot.
2. Turn on your machine and go to the Main menu. Touch the
Embroidery icon.
3. Hoop your 225x140 hoop and attach it to the embroidery unit.
Choose your fi rst design by touching the Mini Main menu
icon. Touch Card/Machine icon and choose Machine. Go to the
PALETTE folder and then choose the MEDIUM folder. In the
MEDIUM folder choose design number M04. Touch OK to bring
the design into the embroidery area.
4. Touch the Move icon (A) and a pop-up appears.
5. Calibrate the hoop by pressing the reverse button on your machine.
6. Place your fi rst design where you want and embroider.
7. Move your fabric to the next desired position and rehoop. Part of
the just embroidered design must be within the embroidery fi eld.
8. Touch the reverse button to calibrate the hoop.
9. Touch the More options icon (B), and then touch the Precise
position icon (C). A new window appears and the Cross-hair icon
(G) is activated.
10. Place the cross-hair where you want the connecting point to be in
your embroidery. Move the cross-hair by using your stylus to move
it around on your screen. Use the Zoom in icon (F) to be able to
make an exact connecting point. Use the arrows (D) for fi ne tuning.
11. Lock the connecting point by touching the Padlock icon (E).
12. Zoom out so you can see the entire embroidery area.
A
B
C
G
F
D
E