Filter
Top Products
Embroidery
5:12
Connecting the embroidery unit
Embroidery unit socket
1. The socket for the embroidery unit (A) is located at the back
of the machine.
Switch off the main switch.
2. Place the embroidery unit directly behind the machine and
pull it into the socket.
Make sure that the guide (B) is slid between the base plate
and the free arm as far as it will go.
3. Raise the embroidery arm in the area of the recessed grip
and turn it to the back.
4. The embroidery arm locks in embroidery position.
Note: You can change bobbin with the unit attached, but make sure that the
accessory tray is not swung too far to the rear. The angle of the accessory tray
should not exceed 90°. Otherwise the embroidery unit could be pushed out of
its socket.
B
A