Maintenance
6:5
Embroidery
Problem/Cause Remedy
The embroidery design is distorted
Did you hoop the fabric strongly enough? The fabric must be tightly hooped, in such a way that no
creases form.
Is the inner embroidery hoop completely attached to the
outer embroidery hoop?
Hoop the fabric in such a way that the inner hoop always
exactly matches the outer hoop.
The embroidery design has contracted
Did you stabilize your fabric suffi ciently? Place a sheet of Adhesive backed paper/stabilizer and/or
Water-soluble stabilizer onto the fabric.
Needle thread breaks
Did you use the right needle? Insert a needle with a larger eye
(System 130N).
Is the needle bent or blunt? Insert a new needle.
Is the thread too thick for the needle? Use the right needle size.
Did you insert the needle properly? Push the needle fully upwards with its fl at side facing the
back.
Did you thread the machine properly? Check how the machine is threaded.
Are you using poor thread with slubs or thread which has
become dry after overlong storage?
Change the thread.
Non-original Parts and Accessories
The warranty does not cover any defect or damage caused by use of non-original accessories or
parts.