Mitsubishi Electronics Q172HCPU Home Security System User Manual


 
4 - 21
4 AUXILIARY AND APPLIED FUNCTIONS
(3) ROM operation procedure
The flowchart to start the ROM operation is shown below.
Mode operated
by RAM
ROM operation start procedure
Set "Installation mode mode written in ROM" as a DIP
switch 5 of the Motion CPU module.
Create or correct the system setting, parameters and
programs using SW6RN-GSV P, and write to the
Motion CPU module.
(Note)
Install the operating system software to the Motion
CPU module using the SW6RN-GSV P.
Set "normal mode" as a DIP switch 5, and set "Mode
operated by RAM" as a DIP switch 2 and 3.
Turn ON the power supply of Multiple CPU system.
Execute the trial run and adjustment.
Set "Installation mode mode written in ROM" as a DIP
switch 5.
Check the operation
Execute the "ROM writing" of the program and
parameter using the SW6RN-GSV P.
ROM operation start
Turn ON the power supply of Multiple CPU system.
YES
NO
(Note) : Do not execute the ROM writing for program and parameter while installing
the operating system software.
Turn ON the power supply of Multiple CPU system.
Installation mode
mode written in
ROM (Install the
operating system
software.)
Installation mode
mode written in
ROM
(ROM writing.)
Mode operated
by ROM
Turn ON the power supply of Multiple CPU system.
Turn OFF the power supply of Multiple CPU system.
Turn OFF the power supply of Multiple CPU system.
Turn OFF the power supply of Multiple CPU system.
Set "normal mode" as a DIP switch 5, and
set "Mode operated by ROM" as a DIP switch 2 and 3.
Execute the trial run and adjustment.