Filter
Top Products
03_NVspec_ver304e
39
Communication Timing
network input config SNVT_switch nciSet_1;
This configuration property defines the network communication start timing at the powering of the LM ADAPTER.
When it is set as "Initialization" and the initial processing between LM ADAPTER and Indoor unit is complete,
communication of Neuron-Chip is possible.
When it is set as "setting time" and the initial processing between LM ADAPTER and Indoor unit is complete,
communication of Neuron-Chip cannot be performed.
When the setting time of a configuration property is performed ,communication of Neuron-Chip is attained.
When it is set as "setting time",communication is started at the shortest setting time in the following configuration
properties.
・nciStartHrtBt（Send Heartbeat Start Time）
・nciStartOutTm（Send Start Time）
・nciInitStartTm（Initialize Start Time）
Valid Range
SW1-7：OFF SW1-7：OＮ
state value state value
0 not used
0 not used
else not used
1 (*1) 0
setting time 1 not used
1 (*1) 0.5% - 100% (*2)
*1:The setting to state=0x02-0xFE is interpreted as state=0x01.
The setting to state=0xFF is invalid.
*2:The setting to over 100% is interpreted as 100%.
Default Value
0(Setting invalid)
Note:
Although reception of an instruction input becomes possible after Neuron-Chip operation starts, a state output cannot
be performed till the time set up with the configuration properties.
Timing
initialize
WSN02-2124 - 48 -