Filter
Top Products
03_NVspec_ver304e
34
Lower Setpoint Cooling
network input config SNVT_temp_p nciCoolLrSetP;
This configuration property defines the temperature setting value for local remote controller cool/dry operation.
The value is set according to nviRmLim (local remote controller temperature range setting).
Valid Range
The valid ran
g
e covers from 19.0 to 30.0 second
(p
er 1.0 ℃
)
.
The settin
g
to -273.17 - 18.99 ℃ results in 19.0℃.
The settin
g
to 30.01 - 327.66 ℃ results in 30.0℃.
Default Value
-0.01℃(judged as 19 ℃)
NOTE: It is possible to use with an "ME" remote controller.
35
Upper Setpoint Heating
network input config SNVT_temp_p nciHeatUpSetP;
This configuration property defines the upper limit temperature setting value for local remote controller heat operation.
The value is set according to nviRmLim (Request Limit Temperature Setting Range).
Valid Range
The valid ran
g
e covers from 17.0 to 28.0 second
(p
er 1.0 ℃
)
.
The settin
g
to -273.17 - 16.99 ℃ results in 17.0℃.
The settin
g
to 28.01 - 327.66 ℃ results in 28.0℃.
Default Value
-0.01℃(judged as 28 ℃)
NOTE: It is possible to use with an "ME" remote controller.
36
Local Operation Lock
network input config SNVT_switch nciRmOpLck;
This configuration property defines the local remote controller simple lock setting value.
The value is set according to nviRmLck (Request Simplified Locking).
Valid Range
SW1-7：OFF SW1-7：OＮ
state value state value
0 not used
0 not used
else not used
1 (*1) 0
except ON/OFF button 1 not used
1 (*1) 0.5% - 100% (*2)
*1:The setting to state=0x02-0xFE is interpreted as state=0x01.
The setting to state=0xFF is invalid.
*2:The setting to over 100% is interpreted as 100%.
Default Value
0(All switches)
NOTE: It is possible to use with an "ME" remote controller.
Operation Lock
All button
WSN02-2124 - 46 -