Filter
Top Products
A
B
C
Third Fixed Knife
As an optional extra, the granulator can be equipped with a third fixed knife to
increase the efficiency of the granulator.
Open the hopper to install/remove the third fixed knife.
CHS series-noise encapsulated machine, remove the rear guard plate over the
motor and open the door.
Removal
1
Undo and remove the screws
(A) which hold the knife.
2 Remove the knife (B).
3 Clean the knife attachments
where the knife was installed.
Installation
1
Install the knife on the knife
attachment.
2 Screw in the socket cap screws
(A), so that the support rule (C)
lightly supports the knife.
3 Press the knife firmly into the
knife attachment to bed it down.
NOTE: The screws in the rear
of the knife attachment are
bonded in place.
NOTE: The knife has a fixed
position and no adjustment
may be done.
4 Tighten the screws (A), with an
alternating tightening torque to 29.50 lb-ft (40 Nm).
Sharpening
The third fixed knife is disposable and is changed
when necessary.
✐
✐
Accessories l 11-5